When a corrugated box sits at the bottom of a pallet stack, its walls carry the load. The Edge Crush Test (ECT) measures how much compressive force a board can handle on its edge before it collapses. An edge crush test chart turns that raw reading into a grade you can compare, specify, and act on.

What the ECT Result Means

In the test, a small rectangular strip of corrugated board is held upright between two platens and compressed until it fails. The peak force is recorded, and the result is expressed per unit of specimen length:

ECT = Peak Force (N) ÷ Specimen Length (mm)

The result is in kN/m (or N/mm), and many markets also quote it in lb/in. A higher value means a stronger board. For a step-by-step look at the formula and machine specifications, read our guide on the Edge Crush Tester: Formula, Calculations, and Best Practices.

How to Read an ECT Chart

A typical chart lists board grades alongside their minimum edge crush values and usual applications. Here is a simplified example:

ECT Grade (lb/in) Approx. kN/m Typical Use
32 5.6 Light, single-wall cartons
44 7.7 General-purpose shipping boxes
48 8.4 Heavier products, longer transit
55 9.6 Double-wall, demanding supply chains

Values are indicative. Always refer to your customer specification or applicable standard.

To interpret your result:

  1. Find your measured value on the chart.
  2. Match it to the nearest grade, rounding down, not up.
  3. Compare it with the required grade for the product weight, stacking height, and storage conditions.

Factors That Affect Your ECT Result

Using ECT Data to Make Decisions